Ein kurzes Update:
Die 3.5" LCDs sollten bald eintreffen und gehen dann sofort an die in der Liste stehenden Personen (soweit bezahlt ist).
Ein Teil der Sammelbestellung ist gestern schon raus, der Rest geht heute raus. Dann wird Deine Sendung beim zweiten Schwung dabei sein.
Have you spoken to Mcwill about this?
I think I and others would feel better knowing he doesn’t feel like you are stepping on his toes.
This is really all a response to him stepping on my toes. One of his followers posted on IG regarding his new GBC LCD kit that is "superior" to my own. I see this as a green light to step into his market. I was completely happy to leave him to the Lynx and GG market until that post.
Competition brings down prices. Do you consider $120 plus shipping a reasonable price for a $6 LCD and maybe $20 in electronics?
Brandon Kick And at that point, it is clear its not a hobbiest supporting the community rather a grab for cash as there is no competition.
it uses the same LCD panel as Mcwills kit, the conversion board I've designed is based on modern FPGA mobile technology which uses almost no power, compared to his older tech and multiple ram video buffers. For this reason my costs per unit are about $10 less than his, and I'm not asking for a ridiculous profit margin on my kits.
You loose VGA but after just spending $350 on an immaculate lynx I have absolutely zero interest in gouging a hole in the case for an antiquated video port.
As for the install, I've designed 3d printed washers with groves cut into them. These sit on the original LCD posts and support the LCD in the X, Y and Z axis. The pcb is so small that it is double sided taped to the rear of the LCD.